Aerospace series. Pins, quick release, single and double acting. Technical specificationBS EN 3777: 2010 Aerospace series. Pins, quick release, single and double acting. Technical specification BS EN 3777 specifies the characteristics, qualification and acceptance requirements for quick release pins, single and double acting for aerospace applications. It is applicable whenever referenced. Contents of BS EN 3777: Foreword 1 Scope 2 Normative references 3 Terms and definitions 4 Classification 4. 1 General 4. 2 Single acting pin 4. 3

It also applies to modules or subsystems whenever the equipment under test (EUT) rated power is greater than the test generator capacity specified in clause 6

The transportation industry

Ecodesign can be understood as a process integrated within the design and development that aims to reduce environmental impacts and continually to improve the environmental performance of the products

S460G2+M - up to and including 100 mm

The application of BS ISO/IEC 90003:2004 is appropriate to software that is:

to adapt the level of safety provided by those standards to the very high level of risk in Zone 0

Administration of distributed information

requirement for edge seal strength comparisons in case of substituting sealant

If the full water flow capacity characteristics of the geotextile or geotextile-related product have previously been established

It defines the level of information appropriate for specific uses including specification of the desired outcome (typically by designers and engineers) and the selection of identified products (typically by contractors and sub-contractors)

Fuel tanks for on-board storage of compressed gaseous hydrogen and hydrogen blends as fuels for land vehicle service are required to maintain or improve the level of safety currently existing for land vehicle applications

Angularity