Philips Hue and Netgear Nighthawk M1 / M2 Rack Mount (Modular)3D Printed 1RU rack mount for the Philips Hue Bridge (V2) and Netgear Nighthawk M1 (also M2) mobile router. This is part of our ModMount Range, so you can mix and match your parts! This item is Omni directional, so you can use it on the left or right side. NOTE: You will need to pair this with another ModMount item (Like a Blanking Plate) to make a full 1RU Width, screws are included to join the parts. The Router and Hue slide into the frame from the

The LM1200 slides into the frame from the front

The device slides into the mount from the front and cables are accessible from the rear

This listing is just for the Mount

Also includes an PSU Mounting arm so that you can secure the power brick

3D Printed 2RU rack mount for 2x GMKTec G5 (N97) Mini PCs

NOTE: You will need to pair this with another ModMount item/s (Like some Blanking Plates) to make a full 3RU Width

3D Printed 1RU Rack mounted shelf

The Mac Mini slides into the frame from the back after removing the back plate which is then screws on to securely hold the device

remove the 4 screws holding each Back in place

3D Printed 2RU 19" rack mount for 3x BeeLink EQR5 / EQR6 & EQi12 Mini PCs

The Home Assistant Yellow slides into the frame from the back after removing the back plate of the mount and the Coral Accelerator slots into the front

The devices slide into the mount from the front and cables are accessible from the rear