Plastics. Film and sheeting. Determination of water vapour transmission rate - Pressure sensor method1 Scope This part of ISO 15106 specifies a method for determining the water vapour transmission rate of plastic film, plastic sheeting, and multi layer structures including plastics, using a pressure sensor. NOTE The method provides rapid measurement over a wide range of water vapour transmission rates.

BS EN 10028-2 on flat products made of steels for pressure purposes is relevant to:

BS EN 1991-1-7 facilitate the safe evacuation and rescue of personnel from the building and its surroundings

provided that the pumping frequency is in the range from 50 Hz to 400Hz

This lets you demonstrate the efficiency and reliability of your steel springs

Service providers for maintenance of machines

pipe cleaners

Flexible sheets for waterproofing are used in a system to prevent the ingress of water into foundations

is prevented from entering the equivalent female contact

The security audit service provides an audit authority with the ability to specify the events which need to be recorded within a security audit trail

They are not intended as a check for computer programs

This International Standard takes precedence over ISO 15004

BS 6472-2:2008 does not give guidance on the probability of equipment malfunction