Mechanical properties of corrosion-resistant stainless steel fasteners - Set screws and similar fasteners not under tensile stressBS EN ISO 3506 3: 2009 Mechanical properties of corrosion resistant stainless steel fasteners. Set screws and similar fasteners not under tensile stress BS EN ISO 3506 3 specifies the mechanical properties of set screws and similar fasteners not under tensile stress made of austenitic stainless steel, when tested over an ambient temperature range of 10 C to 35 C. Properties vary at higher or lower temperatures. BS EN ISO 3506 3 applies to set screws

Vehicle access

gas-powered emergency resuscitators can deliver controlled ventilation for this purpose and BS ISO 10651-5 specifies the criteria they are required to satisfy

Preventing electrical hazard

5 Symbols and abbreviated terms

BS EN ISO 1461 has been revised and the new third edition incorporates changes in content to reflect the experience gained in using ISO 1461

Requirements are given for tolerances on dimensions

Until a new edition of BS ISO/IEC 27007 is published

It also includes requirements for a system of identification of materials used in the construction of these tanks

for welding power sources

Judging compliance with regulations expressed in terms of energy targets

Hazard generated by noise

equipment and other articles during transportation or in service